Publications
Use the filters below to narrow publications by offices, programs or categories
RF Sensors for Spectrum Monitoring Applications: Fundamentals and RF Performance Test Plan
Great emphasis is seen on the networking and data management aspects of spectrum monitoring, but far less attention is given to the radio frequency (RF) sensor systems used to collect the spectrum data. This report focuses on these sensor systems and, in particular, the commercial-off-the-shelf (COTS) RF sensors used in the sensor systems. A test plan for evaluating the RF performance of COTS sensors is outlined. Evaluation of COTS sensors is an ongoing task of the Center for Advanced Communications (CAC) Spectrum Monitoring Program. The intent is to build a comprehensive cost/capability/performance matrix to help guide the selection of the appropriate COTS sensor for a given monitoring scenario. The test plan strives to standardize the tests and metrics, so that results can be compared from sensor to sensor.
Keywords: software defined radio; spectrum monitoring; RF sensor
Speech Codec Intelligibility Testing in Support of Mission-Critical Voice Applications for LTE
We describe a major effort to quantify the speech intelligibility associated with a range of narrowband, wideband, and fullband digital audio coding algorithms in various acoustic noise environments. The work emphasizes the relationship between these intelligibility results and analogous ones for an analog FM land-mobile radio reference. The initial phase of this project includes 54 noise environments and 83 audio codec modes. We use an objective intelligibility estimator to narrow the scope and then design a practically sized modified rhyme test (MRT) covering 6 challenging yet relevant noise environments and 28 codec modes for a total of 168 conditions. The MRT used 36 subjects to produce 432 trials for each condition. Results show that intelligibility depends strongly on noise environment, data rate, and audio bandwidth. For each noise environment we identify codec modes that produce MRT intelligibility values that meet or exceed those of analog FM. We expect that these results can inform some of the design and provisioning decisions required in the development of mission-critical voice applications for LTE.
Keywords: background noise; speech coding; modified rhyme test (MRT); speech intelligibility; audio coding; acoustic noise; ABC-MRT
Using On-Shore Detected Radar Signal Power for Interference Protection of Off Shore Radar Receivers
A spectrum sharing scheme is considered in which ship-based radar stations are operating in the same spectrum band as on-shore communication transmitters, and in which the communication transmitters will cause interference to the radar receivers when interference, I, to noise, N, ratios in the radar receivers exceed a given level (e.g., I/N >= -6 dB). The problem is that on-shore environmental sensing capability (ESC) monitors need to determine whether interference is occurring at off-shore radar receivers based only on information from the radars’ transmitters, with no information available from the victim radar receivers themselves. We describe an on-shore monitoring approach in which the principle of reciprocal propagation between the directions of radar-to-ESC and ESC-to-radar provides a simple go/no-go (single-bit) output from the ESCs to an associated Spectrum Access System (SAS) controlling the communication network, to perform on-shore channel changes for protection of the off-shore radar receivers. The ESC station outputs are based on a power-detection threshold of radar signals at the ESCs (e.g., -64 dBm peak-detected power in 1 MHz bandwidth). Examples are provided in which ship-based radar receivers are protected by a simple algorithm applied to a group of on-shore ESCs and a SAS controller for the terrestrial communication network channel frequencies.
Keywords: radar; radio propagation; antenna gain; spectrum sharing; spectrum access system (SAS); Citizens Broadband Radio Service Devices (CBSD); environmental sensing capability (ESC); interference monitoring
Intelligibility of Selected Speech Codecs in Frame-Erasure Conditions
We describe the design, implementation, and analysis of a speech intelligibility test. The test included five codec modes, four frame-erasure rates, and two background noise environments, for a total of 40 conditions. The test protocol required twenty listeners to repeat all words that they heard in short messages with median length of seven words. Each condition was tested using approximately 1100 words total. Listeners’ responses were scored against the original message transcripts to produce a count of words correctly repeated and thus a measure of speech intelligibility. We present results that show exactly how this measure of speech intelligibility drops as frame-erasure rate increases for three of the five codec modes. The remaining two codec modes did not produce valid results due to defects in the reference software provided to us.
Keywords: background noise; speech coding; packet loss; speech intelligibility; audio coding; frame erasures; acoustic noise
Non-Linear Effects Testing of High Power Radar Pulses on 3.5 GHz Low-Noise Amplifiers
Future spectrum sharing between high-power radars and Citizens Broadband Radio Service Device CBSD in the 3550–3650 MHz (3.5 GHz) band could expose radio frequency (RF) receiver front-end low noise amplifiers (LNAs) to high peak power radar pulse signals in the band under certain situations. In this band, radar effective isotropic radiated power (EIRP) peak levels can exceed 1 gigawatt. Previous experience with LNAs exposed to high-power radar pulses in spectrum near 3.7 GHz has shown that non-linear effects can be induced in the LNAs, leading to service interruptions. To assess the level of risk for similar LNA overload at 3.5 GHz, NTIA performed gain overload (e.g., compression) tests on two representative 3.5 GHz LNAs and a small-cell base station receiver. The tests determined the pulsed radar signal power levels that caused overload (1 dB gain compression) for these devices. Approximate distance separations that would be necessary to preclude potential overload interference effects are presented, based on the measurement results and propagation modeling.
Keywords: radar; spectrum sharing; low noise amplifier (LNA); effective isotropic radiated power (EIRP); Long Term Evolution (LTE); 3.5 GHz band; Citizens Broadband Radio Service Devices (CBSD); non-linear effects; LNA overload; 47 C.F.R. Part 96; General Authorized Access (GAA); Priority Access Licensed (PAL)
Measured Emission Spectra of Selected AWS 3 LTE Transmitters
Version three of Advanced Wireless Services (AWS 3) radio systems will soon use spectrum that is adjacent to bands currently used by airborne telemetry links at U.S. government test and training ranges (TTRs). Spectrum sharing analyses need to be performed to determined how much off-tuning (number of megahertz) and distance separation (number of kilometers) are needed between AWS 3 transmitters and telemetry receiver stations to avoid harmful interference to those receivers. To complete these studies, detailed wide dynamic range emission spectrum measurements of representative models of the soon-to-be-deployed AWS 3 transmitters have been performed. This report describes those measurements, and the method used to obtain them. These measurements have been performed with over 100 decibels (dB) of dynamic range. The measurements have been collected in a variety of resolution bandwidths, transmitter modulations, and types of transmitter loading (i.e., number of resource blocks used) for two measurement detector modes. In general, AWS 3 eNB and UE transmitted emission spectra are found to be insensitive to variations in transmitter configurations. The measured power spectra of the eNBs and UEs vary in direct proportion to measurement (or receiver) bandwidth (i.e., as 10 log measurement bandwidth) with an approximate offset of about 10 dB between peak and average levels. The measurement results indicate that AWS 3 eNB and UE power spectra are suppressed by at least 100 dB in the adjacent telemetry bands for the devices tested. These results can now be factored into EMC analyses for AWS 3 transmitters operating in proximity to telemetry receivers.
The work described in this report was performed by the National Advanced Spectrum and Communications Test Network (NASCTN). Results were published simultaneously as NASCTN Report 4, NTIA Technical Report TR-18-528, and NIST Technical Note TN 1980.
Keywords: band sharing; emission spectrum; spectrum sharing; spectrum measurements; interference analysis; out-of-band (OOB) emissions; 1755-1780 MHz; 2155-2180 MHz; AWS-3; aeronautical mobile telemetry (AMT); Band 66; band sharing analysis; eNodeB (eNB); telemetry links; user equipment (UE)
Intelligibility Robustness of Five Speech Codec Modes in Frame-Erasure and Background-Noise Environments
Frame erasures and background noise are two factors that can interact with speech coding to reduce speech intelligibility and thus impair public safety mission-critical voice communications. We conducted two tests of intelligibility in the face of these factors. The tests covered five adaptive multi-rate (AMR) and enhanced voice services (EVS) speech coding modes, each using a bit rate near 13 kb/s. Two EVS Channel Aware (CA) modes were included. Both tests use the Modified Rhyme Test (MRT) protocol and together they comprise over 150,000 trials. The first test used frame erasures targeted at critical consonants for maximum sensitivity and the second used frame erasures generated at random by a two-state Gauss-Markov model. By using these large numbers of MRT trials we found that the CA codec modes offer small but statistically significant speech intelligibility improvements in numerous frame-erasure environments.
Keywords: noise; speech coding; speech quality; modified rhyme test (MRT); packet loss; speech intelligibility; frame erasures; AMR; EVS; channel aware; frame loss
A 53-Year History of Spectrum Efficiency Studies and Recommended Future Directions
Spectrum is a limited resource upon which the world makes continually increasing demands. It is therefore natural and compelling to study the efficiency with which radio systems use spectrum. Spectrum efficiency studies reveal how future systems can make better use of radio spectrum, and allow spectrum engineers and managers to make better allocation and sharing decisions. This report provides a 53-year historical review of previous domestic and international spectrum efficiency studies. Based on this review, we recommend possible future spectrum efficiency work to extend the state of knowledge in this area.
Keywords: spectrum efficiency; band sharing; spectrum utilization; spectrum sharing; out-of-band (OOB) emissions; spurious emissions; frequency bandwidth; spectrum efficiency metrics
Emission Measurements of a Contraband Wireless Device Jammer at a Federal Prison
This report describes emission spectrum and time domain measurements of a contraband wireless device micro-jammer that was operated temporarily in four Commercial Mobile Radio Service (CMRS) bands at a Federal Correctional Institution (FCI) at Cumberland, Maryland. The four jammed CMRS bands were between 730 MHz and 2.155 GHz. The micro-jammer targeted CMRS service indoors, in a single medium-security prison cell. Spectrum measurements of the jammer emissions were performed at two places inside the targeted prison cell and at two non-targeted nearby locations outdoors. Jammer emission measurements were performed at each location with multiple measurement bandwidths and detectors across a frequency range of 300 MHz to 4.34 GHz. Measurements at each location were performed twice, with the jammer device on versus off, so as to show the relative power levels of the jamming signal versus the ambient CMRS signals at each location. Aggregate emissions from multiple micro-jammer devices such as would be required to cover an entire prison facility were not measured. Jammer emissions are presented in units of power per unit bandwidth in measurement system circuitry; a table for conversion of those data to units of incident field strength in space is provided.
Keywords: electromagnetic compatibility (EMC); harmful interference; aggregate emissions; cellular communications jamming; denial-of-service jamming; emission bandwidth; radio jamming; in-band emissions; commercial mobile radio service (CMRS) jamming; communications jamming; micro-jammer; radiation hazard (RADHAZ); wireless device jamming
Interference Protection Criteria Simulation
Interference protection criteria (IPC) determine the interfering signal power a system can tolerate when sharing spectrum with other services. IPC are typically determined by measurements, but good measurements are often hindered by restrictions on equipment availability and inaccessible intermediate signals, performance metrics, and operational parameters. The purpose of this research is to determine if radio system software simulation can accurately emulate these measurements and alleviate their hindrances. Our approach is to use commercial off-the-shelf (COTS) radio system simulator software to model previous IPC measurement test fixtures and compare simulated to measured results. Measurements of mutual interference between SPN-43C radar and LTE systems are compared. The comparison revealed that 1) when the SPN-43C pulse repetition interval was the same as the LTE subframe period SPN-43C interference in the LTE UE was highly dependent on which OFDM word within the LTE subframe the SPN-43C pulse was repeatedly placed on and 2) simulation is more accurate than measurement for IPC tests with fixed threshold radars such as SPN-43C. These revelations show that simulation is a useful addition and potentially viable alternative to IPC measurement.
Keywords: spectrum engineering; spectrum sharing; electromagnetic compatibility (EMC) analysis; Long Term Evolution (LTE); interference protection criteria (IPC); Citizens Broadband Radio Service (CBRS); radio system software simulation; surveillance radar